HIKMICRO SP Serie Kurzanleitung Seite 128

interference in which case the user may be
required to take adequate measures.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-003 (A)/NMB-
003(A) standards requirements.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
This equipment complies with IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment.
(i) The device for operation in the band 5150-5250
MHz is only for indoor use to reduce the potential
for harmful interference to co-channel mobile
satellite systems;
(ii) The maximum antenna gain permitted for
devices in the bands 5250-5350 MHz and 5470-
5725 MHz shall comply with the e.i.r.p. limit; and
(iii) The maximum antenna gain permitted for
devices in the band 5725-5825 MHz shall comply
with the e.i.r.p. limits specified for point-to-point
and non point-to-point operation as appropriate.
Users should also be advised that high-power
radars are allocated as primary users (i.e. priority
users) of the bands 5250-5350 MHz and 5650-
5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
Conformité Industrie Canada ICES-003
Cet appareil répond aux exigences des normes
CAN ICES-003 (A)/NMB-003 (A).
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radioexempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
ce matériel est conforme aux limites de dose
d'exposition aux rayonnements, CNR-102 énoncée
dans un autre environnement.
(i)Les dispositifs fonctionnant dans la bande
5150-5250 MHz sont réservés uniquement pour
une utilisation à l'intérieur afin de réduire les
risques de brouillage préjudiciable aux systèmes
de satellites mobiles utilisant les mêmes canaux.
(ii) Le gain d'antenne maximal autorisé pour les
appareils dans les bandes 5250-5350 MHz et
5470-5725 MHz doivent respecter le pire limiter; et
(iii) Le gain d'antenne maximal autorisé pour les
appareils dans la bande 5725-5825 MHz doivent
respecter le pire limites spécifiées pour le point-à -
point et l'exploitation non point à point, le cas
échéant.
Les utilisateurs de radars de haute puissance sont
désignés utilisateurs principaux (c.-à -d., qu'ils ont
la priorité) pour les bandes 5250-5350 MHz et
5650-5850 MHz et que ces radars pourraient
causer du brouillage et/ou des dommages aux
dispositifs LAN-EL.
Safety Instruction
These instructions are intended to ensure that
user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
● Use of the product must be in strict compliance
with the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging
while transporting it.
● Keep all wrappers after unpacking them for
future use. In case of any failure occurred, you
need to return the device to the factory with the
original wrapper. Transportation without the
original wrapper may result in damage on the
device and the company shall not take any
responsibilities.
● Do not drop the product or subject it to physical
shock. Keep the device away from magnetic
interference.
Power Supply
● The input voltage should meet the Limited
Power Source (7.2 VDC, 890 mA) according to
the IEC61010-1 standard. Please refer to
technical specifications for detailed
information.
● Make sure the plug is properly connected to the
power socket.
● DO NOT connect multiple devices to one power
adapter, to avoid over-heating or fire hazards
caused by overload.
126