Wolfcraft 5019000 Original Bedienungsanleitung Seite 7

PLEASE NOTE:
Read the safety and all other instructions that come with the cutting stand.
Failing to do so and disregarding the safety and all other instructions may cause injuries.
Keep these operating instructions for future reference in a safe place.
This cutting stand is an aid for cutting work (exclusively for metal) with a one-hand angle grinder.
It is suitable for use with most angle grinders with a disc size of Ø 115 or Ø 125 mm. Carefully read
this instruction manual and especially the safety instructions before using the cutting stand.
Warning of general danger.
Wear a dust mask.
Wear safety goggles.
Wear ear protection.
Wear protective gloves.
Read instructions/information.
• It is imperative that you adhere to the information in the instruction manual for the angle grinder used.
This device must correspond to the VDE standards. Only devices with a CE symbol are to be used.
• Keep children away from the workplace and also keep the tools out of the reach of children.
• Always wear protective goggles, ear protection, protective gloves and a mouth or nose protection
respectively.
• Wear suitable working clothes; do not wear any wide clothing or jewellery as they could be caught
up in moving parts. Non-slip shoes are recommended. Wear a hair net if you have long hair.
• Before use, ensure that the device is correctly and securely mounted in the retainer.
• Never stop the cutting disc with your hands or with objects.
• Mount the cutting stand on both of the mounting perforations in the base plate (1) on the workbench.
Ensure that the bench and the stand are securely positioned.
• Ensure that the workplace is clean and well illuminated.
• Ensure that you do not come into contact with the cutting disc when working. RISK OF INJURY!
• Always use the protective cover (8).
• Only use the cutting stand with an angle grinder which is equipped with the suitable metal protective
cover around the cutting disc.
t
Introduction
Intended use
Symbols and meanings
Safety Instructions
7
Pull out mains plug.
Do not use defective cutting discs.
Use for cutting only, not for roughing.
Exclusively for metal.
Secure workpiece between
the clamping jaws.
Secure cutting stand to a firm
base using suitable screws.
Use only Ø 115 mm and Ø 125 mm
cutting discs.