Polar DB848 Bedienungsanleitung Seite 4

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Reverse the Door
1. Disconnect the appliance from the power
supply.
2. The door is opened from left side originally.
3. Remove the 2 screw covers and screws on the
right top and keep for later use. Then remove
the door and right hinge.
Door
4. Remove the screw covers and screws on the
left top. Then pull out the locking plate.
4
DB848_ML_A5_v1_20191205.indb 4
Locking plate
5. Insert the left hinge (supplied) and secure with
the 2 screws. Then attach screw covers.
6. Remove the bottom spindle from the right foot
and fix it on the left foot.
7. Install the door correctly.
8. Fix the previously removed locking plate to
the right top with screws. Then attach screw
covers.
9. Now the door is opened from right side.
Operation
Thermostat
The thermostat is
located at the rear of
the cabinet.
Turn On
1. Set the temperature to the desired setting:
1 (8°C) to 6 (2°C).
Hinge
2. Close the door of the appliance.
3. Connect the appliance to a mains power
supply.
Lock/Unlock the Doors
• A lock is fitted to the door of this POLAR
appliance.
• Use the keys provided to lock/unlock the door.
Note: Setting the switch to '0'
turns off the appliance.
2019/12/5 18:16