Hama 00014169 Bedienungsanleitung Seite 5

6. Start-up and operation
• Plug the FM transmitter into a car power socket, then estab-
lish the Bluetooth
connection between the mobile device
®
and the FM transmitter as described below.
• Alternatively, audio files can be transferred directly from a
micro-SD card.
Note
• On some types of vehicle, the ignition must be switched on
for the voltage to travel to the 12V vehicle socket. For more
information, please refer to your vehicle's owners' manual.
• Disconnect all cable and vehicle electrical system
connections after use.
6.1 Bluetooth
pairing
®
Note
• Check whether your mobile device (MP3 player, mobile
phone, etc.) is Bluetooth
• If not, you can only use the FM transmitter for playback by
means of a micro-SD card.
• Note that the maximum range for Bluetooth
without obstacles such as walls, people, etc.
• Ensure your Bluetooth
®
that Bluetooth is activated.
• Plug the FM transmitter into a car socket that is close to the
car radio
• Ensure that the FM transmitter is within the Bluetooth
of max. 10 metres.
• Open the Bluetooth settings on your device and wait until
®
the list of found Bluetooth
• Select BT21C and wait until the FM transmitter is showing as
connected in your device's Bluetooth
now shows a transmission frequency.
Note – Bluetooth password
®
Some devices require a password in order to connect to
another Bluetooth
device.
®
• If your device requests a password to connect to the FM
transmitter, enter 0000.
-capable.
®
is 10 metres
®
-enabled device is switched on and
devices shows BT21C.
®
settings. The display
®
Note - connection impaired
After the FM transmitter and device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• In the device's Bluetooth
BT21C is connected. If not, repeat the steps listed under
Bluetooth
• Check whether the device and FM transmitter are less than
10 metres apart. If not, move them closer together.
• Check whether obstacles are impairing the range. If so,
move the devices closer together.
6.2 Audio playback (via Bluetooth
Start and control audio playback accordingly on the connected
device. Alternatively, the audio playback can also be controlled
from the FM transmitter (provided the connected device
supports this).
• Press the function key
• Press the function key
• Press the function key
6.3 Audio playback via micro-SD card
• Insert a micro-SD card into the card slot (6) on the FM
transmitter. Playback starts automatically.
Note
range
®
• The capacity of the micro-SD card must not exceed 32 GB.
• Only the following formats can be played back: MP3.
settings, check whether
®
pairing.
®
)
®
to start or stop the audio playback.
>
to skip forward one track.
<
to skip backwards.
®
2