Lavorwash PRO WORKER EM Bedienungsanleitung Seite 14

14
have been removed.
Inserting the filter: (fig. 8)
(C) Filter in polyurethane foam (only for wet & dry
models)
• The machine must be always kept on horizontal
bases, in a safe and stable way.
• Insert the suitable filters for the proper use.
• Never use the appliance without filters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (-) ON position in order to start the
machine.
☞NOTE: An adequate ventilation rate (dust category
class M ) must be provided for when the outgoing air
is circulated.
•
WARNING: DO NOT connect power tools to outlet
(when using the vacuum for wet pick up.
☞NOTE: Plug vacuum into residual current device (RCD)
protected outlet when using the vacuum for wet pick
up.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
BLOWER FUNCTION
•
CAUTION: function not usable if the appliance is
used to dry vacuum harmful dust.
The appliance can also be used as a blower: remove the
air outlet grid 10 by pressing gently on the closure
tab, remove the hose from the inlet 3 and then insert
the bayonet cap of the hose into the blower outlet
situated inside the lid, behind the air outlet grid, as
shown in fig.4.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
START UP
(0) OFF, SWITCH OFF
(I) ON, MANUALLY OPERATED: VACUUMING
AUTOMATICALLY
CONNECTING ELECTRIC POWER TOOL TO
SOCKET - SOCKET FOR TOOLS
MAX. 2200 W
CONNECTING ELECTRIC POWER TOOLS fig. 9 :
•
WARNING:
- Observe the maximum connected loads for the ap-
OPERATED WITH
pliance socket (Refer to the SPECIFICATIONS.)
- Make sure that both the cleaner and the electric
power tool are switched off before connecting or
disconnecting.
- To connect an electric power tool, open the cap
and insert the power tool plug into the socket of
the cleaner.
- Rotate the switch lever to the "AUTOMATICALLY"
position.
- Switching ON and OFF of the connected electric
power tool simultaneously brings the cleaner
switching on and off action.
At the end of the cycle, the filter shake function will
be activated for about six seconds.
- After use, disconnect the power tool from the so-
cket of cleaner.
- Switch off the cleaner after use.
• Even when rotate switch to position (I) ON
electric tool socket is live.
To clean the filter manually, set the selector
to the symbol of the filter cartridge.
CARE AND MAINTENANCE
•
The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance .
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry
safe place, out of the reach of children.
• A dust-technical inspection is to be carried out at least
once every year by the manufacturer or an instructed
person, e.g. for damage of the filter, tightness against
leakage of the vacuum cleaner and function of the
control unit.
• For category M vacuum cleaners that were in conta-
minated environments, the exterior as well as all ma-
chine parts should be cleaned.
• When performing maintenance and repair work, all
contaminated components that cannot be cleaned to
satisfactory must be disposed of.
• Such components must be disposed of in impermea-
ble plastic bags conforming with the valid regulations
for the disposal of such waste.
REPLACEMENT OF FILTERS
• The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance
, the