ADE Gina Bedienungsanleitung Seite 18

Weighing
Setting up the scale
1. Place the scale on an even, firm and dry surface. Do not place the scale on a carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
Weighing
WARNING against injuries
− Do not step onto the scale with wet feet or when its surface is damp.
Risk of slipping!
− Position yourself on the scale. Stand still and do not hold on to anything.
The measured weight will be displayed shortly thereafter.
A few seconds after you step off the weighing surface, the display will return to "0.0"
and you can weigh yourself again. Otherwise, the scale will switch off automatically
shortly afterwards.
‚ Weigh yourself with as little clothing on as possible.
‚ Try to always weigh yourself at the same time and under consistent
conditions in order to obtain comparable values.
Resetting the scale
Reset the scale to its default settings if unusual or obviously incorrect values are shown
on the display.
1. Remove the batteries from the battery compartment and wait a moment.
2. Reinsert the batteries.
Pay attention to the correct polarity of the batteries (+/-).
After switching the scale on, you can weigh yourself as usual.
Cleaning
NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Never use harsh, scouring or abrasive cleaning agents or the like to
clean the scale. Otherwise, the surface could be scratched.
1. Wipe the scale as needed with a slightly damp soft cloth.
2. Disinfect the weighing surface from time to time using a suitable disinfecting agent
(available at specialist retailers and pharmacies).
18
BE 2011 bathroom scale