Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dismantling the device
Proceed as follows to remove the tubular motor:
Operate the motor to lower the roller shutter, until the roller shutter is no longer
hanging by the springs and these can be easily released from the winding shaft.
DANGER
Fatal electric shock due to coming into contact with live
components.
Do not carry out any connection work on the device when it is
connected to the current supply.
Make sure that the device is disconnected from the mains power
supply.
Disconnect the cable from the junction or switch box.
Release the securing springs from the winding shaft.
Pull the cotter pin out from the securing hole in the drive bearing's axle pin.
Loosen the screws with which the roller capsule and the winding shaft are
screwed together.
Slide the roller capsule up to the limit stop in the winding shaft.
Pull the device out of the bearings.
Pull the tubular motor out of the winding shaft.
Technical data
Torque (Nm)
Rotational speed (rpm)
Voltage (V) / frequency (Hz)
Output (W)
Current consumption (A)
System of protection IP
Maximum operating time
(min.)
Cable length (m)
Total length (mm)
Shaft type
Accessories, included
Limit switch range (U)
superrollo RM10MS
10
17
230/50
121
0.53
44
4
2.0
480
SW40
Adapter, driver, drive bearing,
securing clip, adjustment tool
30
Disposing of the device
The environmentally friendly disposal of operating material, electronic assemblies,
recyclable materials and other parts of the device is regulated by national and
regional laws.
Contact the responsible local authority to obtain precise information on
disposal.
Dispose of the device according to the legal regulations via a specialist disposal
company.
Dispose of electronic components according to the legal regulations in
accordance with the German Electrical and Electronic Equipment Act
(ElektroG).
superrollo RM10MM
10
15
230/50
112
0.49
44
4
2.0
500
SW60
Adapter, driver, drive bearing,
securing clip, adjustment tool
22
superrollo RM20MM
20
15
230/50
145
0.64
44
4
2.0
500
SW60
Adapter, driver, drive bearing,
securing clip, adjustment tool
22
Dismantling the device
superrollo RM30MM
30
15
230/50
191
0.83
44
4
2.0
560
SW60
Adapter, driver, drive bearing,
securing clip, adjustment tool
22
27
Werbung
