EINHELL CE-JS 18/1 Originalbetriebsanleitung Seite 20

7. As soon as the engine is running, remove the
jump start cable from the equipment and then
remove the red clamp from the car battery
fi rst, followed by the black clamp.
8. Let the engine run. The generator will charge
up the built-in car battery.
At very low temperatures a number of jump start
attempts may be required before the car starts up.
Allow one minute waiting time between each att-
empt. Remove the equipment within 30 seconds
after a successful jump start as far as possible.
The number of times that you can attempt to start
the engine (max. 4 within 10 minutes) varies ac-
cording to the ambient temperature, the condition
of the battery you want to start and the charge
level of the jump start power bank battery.
If too many attempts to start are carried out within
10 minutes, the "Correct" LED will fl ash green /
red in alternation and further attempts to start will
be blocked. The jump start function will become
available again after a 10-minute waiting period
provided the battery has enough capacity and the
integrated safety device is compliant.
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the power plug before starting any
cleaning work.
Remove all the connected cables from the jump
start power bank.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a damp
cloth. Do not use cleaning agents or solvents;
these could attack the plastic parts of the
equipment. Ensure that no water can seep
into the device. The ingress of water into an
electric tool increases the risk of an electric
shock.
Anl_CE_JS_18_1_SPK9.indb 20 Anl_CE_JS_18_1_SPK9.indb 20
GB
9.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
10. Repair
Should the tool experience problems beyond
those mentioned above, let only an authorised
professional or a customer service shop perform
an inspection.
11. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
12. Storage
Store the equipment and its accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between +5 and
40°C.
Observe the enclosed safety information with
detailed information about storage. Since the bat-
tery reacts if the temperature is too high (above
+40°C) or too low (below 0°C), do not keep the
battery permanently in a vehicle. For transporting
in a vehicle, place the equipment in a suitable
location where it cannot move in response to an
abrupt change in speed and/or direction. Keep
the equipment in its original packaging.
- 20 -
08.02.2021 10:28:54 08.02.2021 10:28:54