Axis P5522-E Installationsanleitung Seite 12

AXIS P5522–E PTZ Dome Network Camera
Amber/Red
Red
Midspan LED Indicators
LED
Color
Port Unlit
Green
Green, flashing
Green, flashing
AC Green
Connectors and Buttons
For specifications and operating conditions, see page 13.
Network Connector
RJ45 Push-pull Connector (IP66) with High Power over Ethernet (High PoE).
NO TICE TICE
NO NO TICE
Use the supplied midspan.
NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) on
page 2 .
NO TICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
Indication
No camera connected.
Steady when camera connected, normal operation.
Slow flash when overcurrent or short circuit condition
on the port.
Fast flash when input voltage is out of range or other
internal error.
Steady when AC power input connected.
12