Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Impact protection
Overvoltage alarm
Low voltage alarm
Leg difference alarm
Protection against
damage
3.4. Cleaning and maintenance
a)
Use non-corrosive agents only for cleaning the surfaces.
b)
After each cleaning, dry all components well before the appliance is used
again.
c)
Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
d)
Do not spray the appliance with a stream of water and do not immerse it in
water.
e)
Regularly inspect the appliance for technical defects and damage.
f)
Use a soft cloth for cleaning.
g)
Clean with a soft, damp cloth.
the power, remove items from the desk, and turn on the
power again.
"E02": Alerts in case of vibration, collision or tilting while
the desk is moving. Check for vibration, obstruction or
tilt. If the above problems do not occur, perform the
reset process.
"E32": triggers the alarm when the voltage is higher than
required. First turn off the power. Check that the
connection between the power supply and the control
box is fine. Turn on the power again.
"E31": triggers the alarm when the voltage is lower than
required. First disconnect the power. Check that the
connection between the power supply and the control
box is fine. Turn on the power again.
"E60": triggers the alarm when the difference in height
between the left and right leg exceeds the set value. First
turn off the power. Check that the left and right leg are
at the same height. If not, repeat the adjustment process
to correct their height. Turn on the power again.
It stops and enters the protection state when the engine
lines or the manual control lines are accidentally
removed or disconnected; returns to normal after
reconnecting and resetting the alarm.
Werbung
