Herunterladen Diese Seite drucken

FROMM & STARCK STAR ATFE 22 Bedienungsanleitung Seite 35

Höhenverstellbarer elektrischer stehschreibtisch mit doppelschublad

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
2. Press the button (F) to lift the desk top. A single short press lifts the desk top
by 1 cm. A long press lifts the desk top until the button is released or the
maximum desk top height of 120 cm is reached.
3. Press the button (E) to lower the desk top. A single short press lowers the desk
top by 1 cm. A long press lowers the desk top until the button is released or
the minimum desk top height of 72 cm is reached.
4. The button (A) saves the current height setting. Press [A], followed by [B] or
[C], to save the current height setting.
5. Having adjusted the desk top to a convenient height for a sedentary posture,
press [A] to save the height setting and press [B]. The display [D] will briefly
show "H1", which means that the control box has stored the height. Now, the
product will restore the saved height setting when [B] is pressed.
6. Having adjusted the desk top to a convenient height for a standing posture,
press [S] to save the height setting and press [C]. The display [D] will briefly
show "H2", which means that the control box has stored the height. Now, the
product will restore the saved height setting when [C] is pressed.
7. To reset the product's settings, press and hold [E] for 5 seconds, until the
display shows "RES". Once this button is operated, the desk top will go to the
lowest height and then it will rise a bit. The actual height will be displayed after
the resetting process.
Protection mode (automatic screen lock mode)
Protection against
overheating
Sensor missing alarm
Overload protection
"Hot": triggers the alarm when it runs continuously for 2
minutes. Turn off the device and wait at least 18 minutes
before adjusting the height again.
"E10": This alarm occurs when the engine sensor cannot
be detected. Turn off the power. Check the connection
of the engine and the control box, then turn on the
power again.
"E20": Overload alarm. If the alarm occurs when the desk
is lifted, remove items from the desk and try again. In the
event of an alarm when lowering the desk, first turn off

Werbung

loading