Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BILD485 BUILT-IN INSTRUCTIONS
x6
N570-0073 (1/4-20 X 3/8")
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only when not installed with the zero clearance
liner and must be installed and serviced by a qualified installer to local codes.
1. Attach side mounting brackets to each side of the grill using #1/4-20 x 3/8" screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to
each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex
supply line to the fitting at the end of the manifold.
4. The entire installation must be leak tested before operating the unit.
N415-0597CE-GB-DE Nov 04.20
!
10mm
!
APPLY A DAB OF SILICONE
TO EACH FLANGE TO
SECURE IN PLACE.
www.napoleon.com
17
EN
Werbung
