Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation instructions: (Golf, Bora)
Remove the rear bumper cover. To do this first detach the two rear lights at left and right. Then detach
1.)
respectively three screws affixing the bumper in the wheel base, two screws at left and right, a plastic
clip at the left and at the right above the bumper, and two screws from below. Likewise detach the wheel
base covering at left and right (removing one screw from below suffices).
2.)
Remove the rear metal bumper.
To do this detach the two screws respectively at right and left. The screws and the metal bumper are no
longer required.
3.)
Move the side parts of the towing hitch [1] so long from the back into the longitudinal beams of the
vehicle until holes "a", respectively "b", are congruent with the holes in the vehicle. At the same time
guide the connecting cable through the opening in the tail plate.
4.)
Fasten the towing hitch at left and right by using the hexagon screws [7] and washers [9] at "a"
respectively "b". Tighten all four screws with a torque of 55Nm.
Pre-assemble the power outlet and the connecting cable on the towing hitch according to the
5.)
installation instructions for electrical equipment.
Cut out the rear spoiler in the area marked from within.
6.)
Reassemble the complete bumper covering , the rear lights and the wheel housing covering.
7.)
Assemble the ball tow bar [2] and the spacers [4] between the connecting plates of the towing hitch
8.)
base[1]. Affix the ball tow bar [2] with the hexagon screws [6], the washers [8] and the hexagon nuts
[10]. The washer under the left rear screw head - viewed in driving direction - is replaced here by the
power outlet socket [3]. The torque for the M12 screws is 95 Nm. Paint the screw heads and nuts with
black paint, RAL 9005.
Assemble the electrical equipment set completely, using the electrical installation instructions.
9.)
18
18
Subject to alteration.
Werbung
