Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AVANCIS POWERMAX
SAFETY, INSTALLATION AND OPERATION MANUAL
Electrical Ratings of the V NCIS PowerMax
(10 kWh/m²)
All data at Standard Test Conditions: 1,000 W/m² irradiance in the plane of module,
module temperature 25 °C and a spectral distribution of irradiance according to air
mass (AM) 1.5.
PowerMax
®
Nominal power P
nom
Tolerance of nominal power P
Module efficiency
Aperture efficiency
Open-circuit voltage V
Short-circuit current I
sc
Voltage at mpp V
mpp
Current at mpp I
mpp
Limiting reverse current I
Max. system voltage V
Max. system voltage V
Temperature coefficient P
Temperature coefficient V
Temperature coefficient I
Temperature coefficient V
Application Class
The abbreviation "mpp" stands for maximum power point.
Electrical module cables: 2.5 mm² BETAflam
FRNC, halogen free, flame retardant (temperature rating: -40 °C up to +125 °C,
bending radius:
Electrical cable connectors: Lumberg LC4, temperature rating: -40 °C/+85 °C (IEC),
-40 °C/+90 °C (UL)
See the applicable Product Information literature and the label on the V NCIS
PowerMax
®
module backside for more detailed product data.
Disclaimer of Liability
Since compliance with this Safety, Instal-
lation and Operation Manual and the
conditions and methods of handling, in-
stallation, operation, use and mainte-
nance of the PowerMax
yond AVANCIS' control, AVANCIS does
not assume responsibility and disclaims li-
ability for loss, damage, injury or expense
arising out of or in any way connected
with such handling, installation, opera-
tion, use or maintenance of the AVANCIS
PowerMax
®
modules. AVANCIS assumes
no responsibility for any infringement of
patents or other rights of third parties
that may result from use of the Power-
Max
®
modules. No licence is granted im-
plicitly or otherwise under any patent or
patent rights. The information provided
in this Safety, Installation and Operation
14
©2013 | AVANCIS GmbH & Co. KG | Solarstrasse 3 | 04860 Torgau | Germany | E-mail: service@avancis.de | www.avancis.de | January 2013
®
PHOTOVOLTAIC MODULES
105
110
105 W
110 W
-0/+5 % -0/+5 % -0/+5 % -0/+5 % -0/+5 % -0/+4 %
nom
10.0 %
10.4 %
11.0 %
11.5 %
56.0 V
56.7 V
oc
3.22 A
3.23 A
39.0 V
40.2 V
2.70 A
2.74 A
5.0 A
r
(IEC)
1,000 V 1,000 V 1,000 V 1,000 V 1,000 V 1,000 V
sys
(UL)
600 V
sys
nom
oc
sc
mpp
®
4 x outer diameter)
Manual, including product specifications
(without limita tions) and suggestions, do
not constitute a warranty, expressed or
implied. AVANCIS reserves the right to
®
modules are be-
make changes to the product, specifica-
tions or this manual without prior notice.
®
Modules after light soaking
115
120
125
115 W
120 W
125 W
10.9 %
11.4 %
11.9 %
12. 1 %
12.6 %
13. 1 %
57.4 V
58. 1 V
58.8 V
3.25 A
3.26 A
3.27 A
41.4 V
42.5 V
43.7 V
2.78 A
2.82 A
2.86 A
5.0 A
5.0 A
5.0 A
5.0 A
600 V
600 V
600 V
600 V
-0.39 %/°C
-170 mV/°C
0. 1 mA/°C
-140 mV/°C
Class A IEC 61730
Solar Power cables, 125-flex SOLAR
Operation
• Before connecting a PV system to the
grid, make sure the entire system was
checked, tested and approved in accor-
dance with the applicable regulations
for such elec trical systems.
130
• Depending on local regulations and util-
130 W
ity policies, the physical connection to
the grid and start-up of the PV system
may only be performed by an autho-
12.3 %
rised installer.
13.6 %
• PowerMax
®
modules do not require any
59.5 V
routine maintenance.
3.28 A
• AVANCIS recommends that PV systems
44.9 V
are checked periodically for any loose
2.90 A
mechanical and electrical connections.
5.0 A
• Based on regional conditions, Power-
Max
®
modules might be affected by
dust, dirt or other deposits on the top
600 V
surface. This could potentially have neg-
ative effects on the electrical perform-
ance. To clean the surface of the Power -
Max
®
modules from time to time,
AVANCIS recommends using decalcified
water and a soft cloth or sponge to
rinse the front glass (avoid cleaning
agents and abrasives). Only use water
with a temperature that will not cause
too much thermal stress to the module.
In case of questions, please contact:
AVANCIS GmbH & Co. KG
Solarstrasse 3, 04860 Torgau
Germany
Phone: +49 (0)3421 7388-0
Fax: +49 (0)3421 7388-111
E-mail: service@avancis.de
www.avancis.de
Werbung
