tell Adapter2 Schnell-Installationsanweisung Seite 7

Adapter2 / Adapter2 PRO Quick Guide
Service events:
The Adapter2 has various built-in service events on which the device can
perform different actions. To use this option, you must add the service events
you want to use in the Service events menu by clicking on the Add new
button.
Configuring a service event after adding it:
• Enter the Name and select the Type of the event.
• Select the Event from the list.
• You can change the Event code, Partition and Zone if needed.
• Select the Notification template.
Alarm system events:
The Adapter2 can perform different actions upon an event coming from the
connected alarm system. To use this option, you must add the event filters you
want to use in the Alarm system events menu by clicking on the Add new
button.
Configuring an alarm system event after adding it:
• Enter the Name and select the Type of the event.
• Enter the Event code, Partition and Zone.
• Select the Notification template.
Assigning notifications and controls to events:
You can configure notification and output control actions for any event.
Available actions:
• Output control (monostable, bistable, pulse series, or state change).
• Voice call with customizable voice messages.
• IP-based reporting to CMS.
• SMS sending.
• E-mail sending (PRO model only).
• Push message with camera picture option (PRO model only).
Attention! To send Push messages, you must register at least one mobile
device (mobile app) in the Adapter2 PRO!
-> Chapter 4 of the Installation and Application Manual.
7