Restore Factory Settings - HomeMatic IP HmIP-PCBS Installations- Und Bedienungsanleitung

6x long red
flashing
1x orange
and 1 x green
lighting (after
power supply
is applied)
8

Restore factory settings

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the switch circuit board,
please proceed as follows:
• Disconnect the switch circuit board from the
power supply.
• Restore the power supply of the PCB while press-
ing the system button (B) and hold down the sys-
tem button for 4 seconds (see fig. 4) until the LED
(A) will quickly start flashing orange.
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
Device de-
fective
Test display
Restore factory settings
Please see your app
for error message or
contact your retailer.
Once the test display
has stopped, you can
continue.
41