Setting The Recording Time; General Operation; Switching On/Off; Listening−In To Incoming Messages - AUDIOLINE AB 880 Bedienungsanleitung

Setting the recording time

On the rear side of the answering machine is a sliding switch (Seconds 60 120). This switch is used
to set the length of time for a recorded message. You can select between 60 or 120 seconds.
If the caller speaks for a longer period, an acoustic signal is issued and the call is disconnected. If
there is a pause in excess of seven seconds during recording, the call is automatically ended, ac-
companied by an acoustic signal.

General operation

Switching on/off

1. Press the “/s button. The answering machine is switched on, the LED above the
q/p button lights up.
2. Press the “/s button again to switch the answering machine off.
Listening−in to incoming messages
The integrated loudspeaker enables you to listen to messages as they are being recorded. If you do
not want to listen−in to incoming calls, reduce the volume by pressing the Volume button z as of-
ten as necessary.

Interrupting a recording

If you lift the receiver while an incoming message is being recorded, recording is stopped and you
can talk to the caller.

Playing back messages

When the LED above the q/p button is flashing, it means that new messages, memos or
call extracts have been recorded in your absence.
1. Press the q/p button once.
The answering machine plays the recorded messages. The new message recorded is played
back first.
If the LED is not flashing, all recorded messages that you have not yet deleted will be played
back. If no messages have been saved, you will hear several beep tones.
2. To interrupt playback of the messages, press the q/p button.
3. Press the q/p button again to resume playback of the messages.
4. To stop playback of the messages, press the “/s button.
After the last message has been played back, two acoustic signals are issued.

Repeat playback of current message

Press the REC/x button to repeat playback of the current message.

Repeat playback of previous message

Press the REC/x button until the previous message is played back again.

Skipping a message

Press the u/CHECK button once to skip the message currently being played. The answering
machine plays the next message.

Skipping several messages

Press the u/CHECK button several times in succession.
Operation
27