Spare Parts - Rnd Lab Rnd 560-00264 Bedienungsanleitung

Spare parts

Soldering iron
1. Nut
2. Barrel
3. Soldering tip
De-Soldering Iron
1. Barrel and Nut ass'y
2. Soldering tip
3. Heating element
6
EN
4. Heating Element
5. Heater Holder
6. Power Cord
4. Button
5. Ground wire
6. Power cord
PROCEDURE FOR CLEANING CLOGGED TIPS
Caution:
This procedure is to be working in high temperature. Be careful to avoid burning your fingers during this
operation:
• Be sure that the spring wire (included) will not go through the nozzle of the desolder tip.
• Adjust the heating element to a higher temperature allowing the clogged solder to melt. Clean the tip by
sliding the spring wire up and down until the passage is clear. (See Fig. 3)
1. Unscrew the barrel nut assembly as in Figures 4 & 5.
FIG-4
2. Remove the tip by using a pliers as in Figures 6 & 7.
FIG-6
3. Insert the stainless tube of the tip back in the barrel to melt the solder in around 5 seconds
as in Figure 8.
EN
FIG-5
FIG-7
7