Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning
Before cleaning, always switch off the appliance. Disconnect
from the mains or unscrew or switch off the fuse.
• Clean the inside, equipment and outer walls with lukewarm water
and a little detergent. Do not use abrasive or acid cleaners or
chemical solvents.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
Do not use steam cleaners because of the risk
of injury and damage.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Have excessive amounts of fresh food been placed in the appli-
ance?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
• The inside of the appliance may feel warm in places
– That is quite normal. The dissipated heat is necessary for normal
operation of the appliance.
If none of the above causes apply
and you cannot rectify the fault
yourself, contact the nearest
customer service department
stating the type designation
PNC number
and appliance
2
number
as indicated on the
3
type plate.
The position of the type plate
is shown in the section entitled
Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
All types and models are subject to continuous improvement and
the manufacturer therefore reserves the right to make modifica-
tions to the shape, equipment and technology.
24
,
1
Installation dimensions
Assembling decor panels
Decor panel dimensions (mm): Height
• Unscrew handle.
• Unscrew decor frame
.
1
• Loosen decor frames
and slide forwards.
2
• Slide the decor panel
between the frames and the door.
3
• Screw on the decor frames
• Slide all decor frames back and screw tightly.
(mm)
Width Thickness
1221
535
with handle.
1
max.
4
Werbung
