Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operator's guide:
1)Unpacking instructions
2)Rectangular glass shelves
3)Internal cleaning
I
4)External cleaning
5)Connection to the mains
UK
6)Controls
7)Checking correct functioning
D
8)Internal cleaning
9)Replacement of internal light
E
F
WARNINGS
!
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it.
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4
. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
DK
5
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
FIN
7
. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice. 8
B
near sources of heat, such as radiators, stoves, etc.
for at least 30 cm.
GR
12
edges.
. If damp air or products to be refrigerated should cause ice to form on the evaporator, we
recommend stopping the compressor and placing the goods in special refrigerated containers, kept at the
CZ
same temperature, until defrosting is completed;if this is not carried out the compressor will continue to
operate leading to a wasteful consumption of electricity and poor performance.
EE
working and unused, it is indispensable to keep the door open at least 10 cm.
internal use only – do not install outside restaurants, shops.
LV
LT
H
1.
UNPACKING INSTRUCTIONS
CARDBOARD PACKAGING 1a
M
WOODEN CRATE
upwards.
3
. Remove the pallet or crate. . Place the appliance on a horizontal level surface. . Pay attention
PL
anything is left inside the packing. . Separate the packingmaterials according to their type, for easier
disponsal (see picture 1).
SK
2. RECTANGULAR GLASS SHELVES
1
SLO
. Remove door's slilding panels by lifting them upwards and then pulling out the bottom side. . Unpack
the shelves stored on the top of the appliance. . Fix them at the various heights by placing them upon
the plastic brackets on one side, and on the provided supports on the other
supports of special protections devices prevents the shelves from sliding. . Place door panels back into
place, taking care in having both handles on the outside
3. INTERNAL CLEANING
1
. Only clean the internal surfaces and glass panels with a soft,wet sponge and a neutral detergent.
2
. Dry with care using a soft cloth.
4. EXTERNAL CLEANING
1
. Use the same products as used for the internal cleaning. . Remove the protection plastic white tape
from the steel of the grids.
the corners
(see picture 3).
5. CONNECTION TO THE MAINS
1
.
Ensure that mains voltage and frequency are the same as those stated on the rating plate ( ) attached
to the appliance. . Ensure that the supply socket has the following characteristics:
earthed. It is appropriate for the nominal current as set out on the rating plate. It complies with the IEC
b)
regulations: Magneto-thermic differential switch with In = nominal value as stated on the rating plate;
-
Differential with Id sensitivity = 30 mA.
4
.
The connecting cable to the appliance is H05 VVF, designed for internal use only.
not use triple and reduction outlets (See picture 4).
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance
11
. Ensure that the products displayed on the shelves and grills do not hang over the
. Cut surrounding tape. Remove the cardboard packaging by sliding
1b
. Remove the nails from the wooden crate with care. . Lift the appliance.
4
6
3.
Cut the white protection tape of the side panel and remove it by seizing by
2
3
Operator's guide
Maintenance manual (Page 50):
1)Cleaning the condenser
2)Replacement of a fixed glass panel
3)Replacement of the evaporator's internal fan
4)Wiring diagram diagram of refrigeration unit
10
. Keep the ventilation grills free from obstruction
3
(see picture 2).
2
. Ensure that there is no danger of explosion (AD) in the room.
6
3
9
13
. If the appliance is not
14.
Our products are for
2
5
2
. 4
. The presence on the
5
A
It is properly
a)
c)
5
.
Insert the plug,do
2
. It
-
Werbung
