Landxcape LX835i Benutzerhandbuch Seite 22

The green light on the charging station
turns on before charging is complete.
TM
Landxcape runs outside the boundary
wire.
TM
Landxcape does not mow an area
within a boundary wire zone.
TM
Landxcape reverses or rotates
erratically near the boundary wire.
TM
Landxcape wheels skid or damage
lawn.
TM
Landxcape exits the boundary wire
due to high speed when going down a
hill.
TM
Landxcape runs in circles; turns right
or left even there is no obstacle in front
of it.
Keyboard of the mower fails to work.
Mower fails to avoid obstacles.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
22
The charging station is overheated.
The boundary wire has been installed with
tight corners.
The cutting area is larger than the allowable
TM
cutting area for Landxcape .
The boundary wire of another Landxcape
or another robotic mower is positioned too
closely.
In wet conditions, the boundary wire electric
signal may leak were wire has been joined or
repaired.
There is boundary wire electric signal leakage
due to broken insulation.
Foreign obstacles, such as twigs and branches
TM
may be lodged under Landxcape
The lawn is too wet.
The boundary wire is placed on a slope
steeper than 17% (10°).
Software update failure occurs.
The boundary wire of another Landxcape
or another robotic mower is positioned too
closely.
Keyboard is damaged.
Poor connection for the cable between the
control panel and the mainboard or the cable
is damaged.
Keyboard needs to be reset.
The boundary wire of another Landxcape
or another robotic mower is positioned too
closely.
The obstacle is lower than 10cm.
Place the charging station in a shady area or wait
until the temperature has cooled down.
Check the boundary wire to ensure the corners are
smooth.
Reduce the cutting area or use Landxcape
larger allowable cutting area.
TM
Ensure your Landxcape
1m of space between the neighboring boundary wire.
Check boundary wire joints. Insulate to provide a fully
waterproof connection.
Repair damaged boundary wire insulation with
connectors.
Remove foreign objects from underside of
TM
. Landxcape .
Wait until lawn has dried.
Reposition the boundary wire away from slopes that
are steeper than 17% (10°). Please refer Installation
Guide for details.
Try again according to section "Software update".
check and ensure your Landxcape
TM
has at least 1m of spacing between the neighboring
boundary wire. If the problem cannot be solved,
please contact Landxcape
Restart Landxcape
pressing the on/off key for 10 seconds and then
restart Landxcape TM
please contact Landxcape
check and ensure your Landxcape
TM
has at least 1m of spacing between the neighboring
boundary wire. If the problem cannot be solved,
please contact Landxcape
This is normal.
TM
with a
TM
boundary wire has at least
boundary wire
TM
service agent for help.
TM
TM . If the problem persists, keep
. If the problem cannot be solved,
service agent for help.
TM
boundary wire
TM
service agent for help.
TM
EN