Landxcape LX835i Benutzerhandbuch Seite 19

Landxcape TM is powered off. (See Fig. O)
3. The green light on the charging station will be flashing.
8.4 Winter hibernation
TM
Your Landxcape will live longer and healthier if it is allowed to hibernate. So even though it is troublesome, we recommend storing your
TM
Landxcape in your shed or garage during the winter.
Before you prepare your Landxcape
• Thoroughly clean your Landxcape
• Fully charge the battery and remove it from Landxcape
• Turn power off
To maximize the battery life, fully charge the battery and remove it from Landxcape
WARNING: Protect the underside of Landxcape
The boundary wire can be left in the ground but its ends should be protected, such as placed in a tin can with grease. If the charging
station is left outside for the winter, leave the boundary wire connected.
NOTE: When bringing Landxcape
TM
using a fine grade emery cloth to clean the contacts.
8.5 Replacing the battery
WARNING: Power off before attempting any adjustment, replacement or repair.
Before replacing the blades, turn your Landxcape
If you need to replace the battery, follow these steps:
TM
1. Gently turn your Landxcape
2. Remove the screws on the battery cover. Remove the battery cover. (See Fig. P1)
3. Lift out the old battery carefully. Press the latch and release the connectors. (See Fig. P2)
NOTE: Do not pull by the cables. Hold the connectors and release the latch.
4. Connect a new original battery by attaching the connectors until they click into position. (See Fig. P3, P4)
5. Fit the battery as shown. (See Fig. P5) Place the cover back in its position and tighten the screws.
9. Function Messages
Display
Rain delay activated.
10. Error Messages
Display
Landxcape
working area.
Wheel motor blocked
EN
TM
for winter hibernation, we recommend you:
TM
TM
TM from water. NEVER store Landxcape
back to work after winter hibernation, make sure the charging strips and contact pins are clean. We recommend
TM OFF and put on protective gloves.
upside down.
Message
Cause
1. If Landxcape
inside its territory. Turn Landxcape
2. If Landxcape
verify that the charging station is properly connected to the charger and that the charger is
TM
is outside
connected to a suitable power supply. If they are properly connected, the boundary wires are
clamped incorrectly and must be reversed.
3. If the LED light on the charging station turns on red, confirm that the boundary wire is
well connected to the clamps on the charging station. If the problem persists, check that the
boundary wire hasn't been cut.
1. Turn Landxcape
2. Turn Landxcape
3. If the error message is still displayed, turn power off; turn Landxcape
check if there's anything preventing the wheels from rotating.
4. Remove any obstruction, turn Landxcape
Landxcape TM will begin to charge.
TM
before storage during winter.
TM upside down outdoors.
No action is required.
Action
TM
is actually outside its territory: turn Landxcape
TM
on. Press then
TM
is inside its territory, check if the LED on the charging station is green. If not,
TM TM
off; take Landxcape to an area free of obstacles.
TM
on. Press then .
TM
upright, turn power on. Press
Action
TM TM
off, take Landxcape
.
TM
upside-down and
then .
19