Sundirect Smart2.0Pro Montageanleitung Seite 4

3. Operation
3.1 Pair to the receiver
All "Plus" range heaters have a built-in thermostat
receiver-Receiver01 on the backside of the panel.
On the right, see the drawing of the signal lights
and button of Receiver01. The following is a
detailed description of the buttons and signal
lights:
1.Pair status signal light (green light)
2.Heating status signal light (red light)
3."P" button
4. Power switch
Step1: Plug your heater to an electricity outlet, switch the Power switch of
Receiver01 on, double press the "P" button and the "Pair signal light" will
start to flash and is ready for pairing.
Step2: Power-off the Smart2.0Pro, long press the "SET" button. The "PAIR"
signal will show on the screen of the remote control. Wait until the "Pair
signal light" stops flashing and glows green to finish the pairing.
Note: Once Receiver01 and Smart2.0Pro are paired, the pair signal light will
always be on and the Receiver01 will be only commanded by the
Smart2.0Pro. One Receiver01 can only pair to one Smart2.0Pro, however, one
Smart2.0Pro can be paired to up to 10pcs Receiver01 if they are in the same
room.
3.2 Time settings and
temperature calibration
Power on Smart2.0Pro. Press the
"SET" button for 3 seconds to
enter the settings. The screen on
the thermostat will show as below
and the minutes of the timer
4