eta FOGOS MAX Bedienungsanleitung Seite 20

EN
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the ventilator. Remove all possible adhesion
foils, stick-on labels or paper from the appliance. Place the ventilator on a suitable place.
Plug power cord connector A3 to an electric socket. Set main switch A1 to „I". Audio signal
will be heard and „--" will appear on the display B7 to indicate that the device is in standby
mode and ready for operation.
Inserting the battery to remote control (C)
Insert the battery into the remote control as shown on fig. 1 (battery type: 1x 3v CR2025;
included). Observe correct polarity.
CONTROL
Button *
Marking Symbol
B1
C1
B2
C2
B3
C3
B4
C4
B5
C5
B6
C6
* The buttons on the LED control panel are marked B1-B6, the buttons on the remote
control are marked C1-C6. Their function is the same, i. e. B1 function corresponds to
C1 function etc.
LED touch panel (B) / Remote control (C)
1st pressing – switching on the device;
2nd pressing – switching off the device (switching to standby
mode).
1st pressing – oscillation on;
2nd pressing – oscillation off.
Press repeatedly to set the timer (operation time of the device),
setting range 0–9 hours (1 pressing = 1 hour). Depending on set
values, "0h" – "1h" – "2h" – ... – "9h" will be displayed on B7. After
expiration of set period of time, the device will be switched off.
Press repeatedly to set the temperature. Six temperature values
can be set: 10 °C, 15 °C, 20 °C, 23 °C, 27 °C and 30 °C. Set
temperature (e.g. "23").will be displayed on B7.
This button is used for switching on/off heating and adjustment of
the heating intensity. Set mode is displayed on B7:
1st pressing "H0" – heating is off, only the fan is active;
2ns pressing "H1" – heating is on, low intensity (1350 W);
3rd pressing "H2" – heating is on, high intensity (2000 W).
Switching on/off B7 display backlight and adjustment of backlight
intensity. Three intensity levels can be set:
1st pressing – medium backlight level;
2nd pressing – low backlight level;
3rd pressing – backlight off;
4th pressing – high backlight level.
EN - 20
Function