yeep.me 00c Bedienungsanleitung Seite 15

WARNING: The device must be unfolded and on its stand for charging to avoid
EN
damaging the charging plug.
1. Remove the charging port cover and ensure there is no water or any other
liquid inside the charging connector, and that it is free of any objects that
could cause a short circuit or prevent the plug from being properly and safely
plugged in. Next, connect the end of the charging cable to the charging port
(7). BEFORE connecting the other end to the power supply. BEFORE connecting
the plug to the mains, ensure that the charger is first connected to the device
correctly by referring to the codes on the device.
2. The charger indicator will light up red when charging.
3. The charger indicator will light up green once charging is complete.
4. When charging is complete, disconnect the mains plug from the outlet
first, then unplug the charger from the device. Finally, close the cover to
prevent liquids or other objects from entering the charging connector.
3.5. PREPARATION
For your own safety, we recommend you use this device in comfortable
conditions, wearing protection equipment such as a helmet and appropriate
protective gear for your joints (knee pads, elbow pads). For your own safety
as well as that of others, drive the scooter wearing closed and preferably
flat shoes to ensure you have a good grip and stability.
Helmet
Elbow support
Wrist guard
Knee pad
15