yeep.me 00c Bedienungsanleitung Seite 14

3.3. FOLDING/UNFOLDING THE DEVICE
EN
The scooter can be folded and unfolded easily thanks to the release lever (8).
and the folding/unfolding safety lever (9). You should always perform this
operation with care in order to avoid getting pinched or jammed.
Unfolding
1. Place the device in front of you in a horizontal position.
2. Start unfolding by pushing the lever (8).
3. Lift the scooter frame by about 90 degrees until you hear a soft click.
4. Lift and close the release lever (8). until it fully engages the hinge.
5. If the device is equipped with fold-away handles, set them up by pulling
them apart. If not, the handles are already set up in the correct position.
6. The process is complete.
Folding
1. Place the device in front of you in a horizontal position.
2. If the device is equipped with folding handles, fold them away to the sides
if needed.
3. Unlock the device by lowering the lever (8).
4. Push the folding lever (9).
5. Lower the scooter frame by 90 degrees.
6. The process is complete.
3.4. CHARGING AND BATTERY INDICATOR
Charge the battery before first use. To do so, charge the device using the
charger supplied.
WARNING: All charging operations must be performed with the original
charger (charger part number listed in the "CONTENTS AND TECHNICAL
DATA" section) supplied with the unit.
The external flexible cable of this transformer cannot be replaced; if the cable
is damaged, the transformer must be disposed of.
If in doubt, lost or malfunctioning, do not charge the unit with another charger.
A new one should be obtained from your dealer. You will find the email of the
support to contact on the last page of the warranty manual.
Next, check the battery charge level before use, using the battery level
indicator (18).
14