Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SMP439-11
• Disconnect the device from the mains:
– Before working on the device
– Before cleaning and maintenance
– After use
• If you disassemble the device:
– Detach all connections.
– Make sure that no voltage is present at any of the inputs and out-
puts.
A
NOTICE!
• Ensure connection to mains is in accordance with national wiring rules.
• Ensure that other objects cannot cause a short circuit at the contacts
of the device.
• Never pull the plug out of the socket by the connection cable.
2.2
Safety when installing the device
D
DANGER! Danger of electrocution
• Do not touch exposed cables with your bare hands. This especially
applies to all cables in the AC mains circuit.
• If you are working on electrical systems, ensure that there is somebody
close at hand who can help you in emergencies.
• Never mount the device anywhere where there is a risk of gas or dust
explosion.
!
CAUTION!
• Observe the applicable Volkswagen installation regulations regarding
the installation position of the device.
• The battery charger must be plugged into an earthed wall-socket.
• The place of installation must be well ventilated. A ventilation system
must be available for installations in small, enclosed spaces.
• Ensure that the device is standing firmly.
• The device must be set up and fastened in such a way that it cannot tip
over or fall down.
• Ensure a sufficient cable cross-section.
• Lay the cables so that they cannot be tripped over or damaged.
• Fasten the cables securely.
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
EN
Safety instructions
7
Werbung
