Cleankeys CK4+CK4W Bedienungsanleitung Seite 2

Supplement to the user manual CK4W
Putting the CK4 into service (wired version)
Connect the keyboard's USB cable to a free USB port on your computer. The initialization procedure is taking
place when the LED lights flash on the status bar. This procedure may take a few seconds; the time required
depends on the system that you are using. The driver initialization is confirmed by the operating system through
a final single chase of the LED lights. After this, the keyboard has been registered on your computer as an HID
keyboard. You can now use the keyboard without any problems.
Using the CK4W for the first time (wireless version)
Charging the keyboard:
• If a new k yboard is being used for the first time, first fully charge the battery. The
device must be switched on using the On/Off button before starting the charging process
Linking the dongle & keyboard:
• Place the USB dongle in one of your computer s USB ports.
• Switch the k yboard on by pressing the On/Off button.
• Once the k yboard has been switched on, the row of LED lights is illuminated sequentially (chase) and the
USB dongle has a red light as long as the keyboard and the dongle have not been connected to each other.
If the LED lights do not come on after the keyboard has been switched on, there is not enough power in the
battery and it needs to be charged.
• You create the connection between the two devices by briefly pressing the "Connect" button on the keyboard
and USB dongle.
• As soon as the connection has been made, the chase goes off and the light on the dongle turns green.
• The keyboard is then ready for use.
Please note the following when using the CK4W:
• As long as the connection between the dongle & the keyboard is established, the keyboard remains switched
on.
• If the connection between the k yboard and the dongle is interrupted (e. g. switching off the PC), the keyboard
switches off automatically after 3 minutes. This is not a sleep or standby mode.
The keyboard is fact switched off (AKKU protection). You need to switch on the keyboard with the On/off button
to use it again.
• When shutting down the PC and the USB port (light of USB dongle is switched off), the CK4W can either be
switched off with the On/Off button or it switches itself off automatically after 3 minutes. If the USB port is not
switched off with shutting down the PC (USB dongle light remains green) the CK4W needs to be switched off
manually using the On/Off button.
• Once the PC has been booted the keyboard needs to be switched on again using the On/Off button.
• The pairing action (pressing the "Connect" button on the keyboard and the dongle) is, however, only necessary
when using the unit on a PC for the first time.
• In order to charge the b ttery, the keyboard must also be switched on (using the On/Off button).
www.gett-group.com | www.gett.de
EN