urmet 1092/165H Bedienungsanleitung Seite 19

INSTALLATION
1 Make sure that no units are powered before starting the installation procedure.
2 Remove the CCD cover.
3 Fit the lens on the camera.
4 Connect the wire to the AUTO-IRIS connector .
5 Connect the CCTV camera to the other devices of the system using an approved 75 ohm coax cable.
6 Power the camera.
7 Make the adjustments required (see paragraph below)
FOCUSING PROCEDURE FOR AUTO-IRIS LENSES
1. Fit the optics on the camera.
2. Connect the wire to the Auto-Iris connector.
3. Adjust the zoom
4. Select the lens to MANUAL (see EXPOSURE menu) and the shutter to AUTO (see
EXPOSURE/E.SHUTTER menu)
5. Adjust the focus.
6. Restore the lens to DC
USING COMMANDS AND PRESETTINGS
Button menù
DS1092-347B
All manuals and user guides at all-guides.com
19