Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dear MAGNAT Customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing MAGNAT! You have
made an excellent choice. The high-quality speakers produced by MAGNAT are renowned all over the world.
Please study the instructions and information below carefully before using your new loudspeakers.
maGnat Cinema Ultra
The LCR 100-THX front speaker and the RD 200-THX dipole surround sound speaker are both parts of the
Magnat Cinema Ultra loudspeaker family. Other models include the SUB 300-THX subwoofer and the Dolby
Atmos-compatible AEH 400-ATM universal add-on speaker.
A 5.1 system comprising three LCR 100-THX front speakers, two RD 200-THX dipole surround sound speakers
and one SUB 300-THX subwoofer meets the requirements of the THX Ultra2 standard. The system can be
expanded without any difficulty (e.g. a second subwoofer for 5.2 or further surround sound speakers for 7.2).
In addition, all the models can also be used outside the Cinema Ultra range and with non-THX-licensed devices
as extremely powerful home cinema components.
General inFOrmatiOn
Please always use a good quality loudspeaker connection cable from an audio dealer. To prevent impairment
of sound quality, we recommend cables with cross-sections of at least 2.5 mm² for lengths up to 3 m and at
least 4 mm² for lengths above 3 m.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables. Place the
loudspeakers in their planned positions and cut the cables to the right length. The cables for both channels
should always be exactly the same length.
Strip 10 – 15 mm of insulation from the ends of the cables. Twist the ends – this is much better than tinning
them with solder – insert them in the terminals and tighten the terminal screws firmly (fig. 1). Loudspeaker
cables with CE-compliant banana or single-pin plugs (4 mm) or forked fittings can also be used.
For good sound it is imperative that the cables must be connected in such a way that the speakers are "in
phase". This means that the black negative terminals on the speakers (-) must be connected to the negative
(-) terminals on the amplifier, the red positive (+) speaker terminals to the positive (+) amplifier terminals. To
make this easier one wire of most speaker cables is marked with a coloured strip or a ridge in the insulation.
Before switching on the system double-check all your connections and make sure that the terminal screws
are tight and that there are no short circuits caused by stray wire filaments – this could cause serious damage
to your amplifier!
General remarKS COnCerninG SetUP
The LCR 100-THX front speaker complies with the THX Ultra2 standard for vertical and horizontal operation
in all positions. This results in a variety of setup possibilities (Fig. 2 a-d). In mixed operation mode combining
vertical and horizontal positioning, it is advisable, for acoustic reasons, to have identical alignment of the
left and right speakers.
The loudspeakers offer several options for wall mounting. Wall-mounting brackets are fitted at the rear, with
both vertical and horizontal alignment possible in the case of the front speaker. Alternatively, the speakers
can be mounted using a VESA standard wall bracket. Distance between the holes:
- 200x200mm M6 for the LCR 100-THX front speaker
- 200x100mm M4 for the RD 200-THX dipole surround sound speaker
Four self-adhesive rubber feet are included for the front speaker for setting up on a loudspeaker stand or shelf.
6
Werbung
