Coccolle Nova Bedienungsanleitung Seite 15

EN
For Group I installation, this seat also can use vehicle belt only, it has been
tested and homologated also. If you want only use vehicle belt installation, just
skip the ISOFIX connector relative content.
5.3 Group II III(15-36kg,approx. 3 years to 12 years) forward facing
Remove harness when use as group II,III see section 4.8 Rotate seat to forward
facing (see section 4.5). Place seat in the direction facing to the travel. (fig55,56)
Install ISOFIX connectors (see section 4.6) (fig.57)
(If your seat don't equipped ISOFIX or your car don't equipped ISOFIX
anchorage, please install only use 3-point belt).
Have your child sit down in the child seat. Adjust headrest in proper height (see
section 4.3). Pull out the vehicle seat belt and guide it in front of your child to the
vehicle seat buckle. Engage the buckle tongue in the vehicle seat buckle.
(fig.58)
Caution! The vehicle seat belt buckle must not be positioned in the lower belt
guide
Place the diagonal seat belt section and lap belt section on the side of the
vehicle seat belt buckle in the lower belt guide. (fig.59)
Place the lap belt section on the other side of the childseat in the lower belt
guide.(fig.60)
Caution! The lap belt section must lie as low as possible over your child's hips
on both sides
Guide the diagonal seat belt section into the belt and is not twisted. (fig.61)
For the safety of your child, before every journey in the car check :
- the child safety seat is engaged on both sides with the ISOFIX connectors in
the ISOFIX attachment points and that both buttons are green;
- the child seat is firmly installed in the vehicle;
- the lap belt section runs through the lower belt guides on both sides;
- the diagonal seat belt section on the side of the vehicle seat belt buckle also
runs through the lower belt guide;
- the diagonal seat belt section runs through the belt holder of the headrest
- the buckle is engaged, belt is not twisted ;
For Group II III installation, this seat also can use vehicle belt only, it has been
tested and homologated also. If you want only use vehicle belt installation, just
skip the ISOFIX connector relative content.