Coccolle Nova Bedienungsanleitung Seite 12

EN
4.6.2 Remove ISOFIX
Push the child seat towards the backrest applying firm.(fig23)
At the same time squeeze ISOFIX button and pull back ISOFIX
connectors.(fig.24)
Take the top tether and if required, lengthen the belt by pressing the top tether
brake button to release the strap, pulling to adjust as necessary.(fig25)
Attach the top tether hook to the top tether anchorage point which is
recommended in the owner's manual of your car. (fig.26) Look for this
symbol in your vehicle
To tension the top tether, remove any slack by pulling on the free end of strap
until it is suitably tightened. The top tether will be properly tightened
when the tension indicator turns completely green. (fig.27)
4.8 Remove and install harness
Unhook the shoulder belts on the back side of the child seat from the
yoke.(fig.28)
Store the yoke in the bag of fabric cover. (fig.29)
Unhook the shoulder pad straps from the Connecting piece. (fig.30)
Pull out both the shoulder pads and the two shoulder belts from the slots.(fig.31)
Open buckle. (fig.32)
Roll the shoulder belts together and store them in the bag of fabric cover.(fig.33)
Grasp the metal plate from underneath and turn it into a vertical position. Push
upwards and slide the metal plate through the slot. (fig.34)
Re-fitting the harness: Simply follow the steps in the opposite order. Make sure
the belt is not twisted.
5. INSTALLATION
5.1 Group 0+ (0-13kg,born to approx.18 months) rearward facing DO NOT place
rear-facing child seat on front seat with active airbag, DEATH OR SERIOUS
INJURY can occur.
Rotate seat to rearward facing (see section 4.5), adjust seat in most reclined
position (see section 4.4). Place seat in the direction facing opposite to the
travel. (fig.35,36,37) Infant cushion is for child below 9kg.