Coccolle Nova Bedienungsanleitung Seite 13

EN
5.1.1 Install use ISOFIX connectors and Top tether
(If your seat don't equipped ISOFIX or your car don't equipped ISOFIX
anchorage, please see section 5.1.2 Install use 3-point belt).
Install ISOFIX connectors (see section 4.6) (fig38)
Guide top tether along both sides, then attach top tether hook to anchorage
point. (see section 4.7) (fig.39)
Have your child sit down in the child seat. Adjust headrest in proper height (see
section 4.3), adjust harness and lock buckle (see section 4.1), and tighten
harness. (see section 4.2) (fig.40)
For the safety of your child, before every journey in the car check :
- the child safety seat is engaged on both sides with the ISOFIX connectors in
the ISOFIX
attachment points and that both buttons are green;
- the child seat is firmly installed in the vehicle;
- the Top Tether is tightly tensioned over the backrest of the car seat and the
tension
Indicator is green;
- the straps of the child safety seat are close to the body without constricting the
child;
- the shoulder belts are correctly adjusted and the straps are not twisted;
- the shoulder pads are at the same level as your child's shoulders;
- the buckle latches are engaged in the harness buckle ;
5.1.2 Install use 3-point belt
Open buckle then remove infant cushion. (fig.41)
Guide vehicle lap belt through both lower belt guides, engage the buckle
tongue in the vehicle seat belt buckle. (fig.42) Put infant cushion back.
Caution! The vehicle seat belt buckle must not be positioned in the lower
belt guide.
Pull the diagonal belt strongly to tighten (hold tension) and clamp the lock-off
device on diagonal belt as close to vehicle seat belt buckle as possible. (fig.43)
Guide the diagonal belt around seat back then through upper belt guide which in
the same side of vehicle seat belt retractor. (fig.44)
Have your child sit down in the child seat. Adjust headrest in proper height (see
section 4.3), adjust harness and lock buckle (see section 4.1), and tighten
harness. (see section 4.2) (fig.46)
Shake the child safety seat to make sure it firmly installed in the vehicle. (fig.45)
Caution! Belt is not twisted, buckle is engaged.