eeese Emma Bedienungsanleitung Seite 97

7. Storage
If the dehumidifier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank, make sure the tank and the
dehumidifier is completely dry. This may take a couple of days.
2. Clean the pre filter.
3. Check the dehumidifier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidifier in a dust-free location, and out of direct sunlight.
Preferably covered with a sheet of plastic.
8. Display error codes
Please contact our eeese service line if any of the error codes below appears.
DISPLAY
CODE
Error
Display
What is
happening
MV-2567-03-2023 eeese-aircare.com © All rights eeese air care aps
E1
The temperature The humidity
sensor error sensor error
Flash every Flash every
30 seconds 30 seconds
The device
works normally,
The device works
normally.
but can't set
the humidity
E2 L3
The air inlet
temperature is
too high >42°C
Slowly flash L3
The compressor
stop working,
fan works at
low fan speed.
10 mins later, if
the temperature
decreases to
below 40°C,
thedevice will
work normally.
UK
L4
The air inlet
temperature is
too low <0°C
Slowly flash L4
The
compressor
stop working,
fan works
at low fan
speed. 10 mins
later, if the
temperature
increases to
above 2°C, the
device will work
normally.
97