Venicci ENGO Bedienungsanleitung Seite 10

Installation in the vehicle
4.1 Securing the infant carrier in your vehicle
To securing the infant carrier using the 3-point belt of your
vahicle proceed as follows:
Place the infant carrier rearward-facing on the vehicle seat (baby is facing
backwards).
Tip! In certain cases it is possible that the infant carrier does not rest securely
it is inclined too steeply on the vehicle seat.
Ensure that the handle is its upper position D.
Pull out the vehicle seat belt and place it across the infant carrier.
Engage the buckle tongue in the vehicle seat buckle.
Place the lat belt section in the green belt guides in both sides of the
infant carrier.
Caution! Do not twist the belt.
Tighten the lap belt section by pulling the diagonal belt section.
Pull the diagonal seat belt section behind the top end of the infant carrier.
Caution! Do not twist the belt
15
Installation in the vehicle
4.2 Checlist for the correct installation of the infant
carrier in your car
For the safety of your baby, please check that...
• The infant carrier is installed rearward-facing.
• The infant carrier is only installed on the front passenger seat if no front
airbag can strike the infant carrier.
• The infant carrier is only secured using a 3-point belt.
• The lab belt section runs through both green guides on the infant carrier.
• The diagonal belt section runs through the light green belt guides on the
infant carrier.
• The vehicle seat belt is tightened up and not twisted.
16