Herunterladen Diese Seite drucken

Makita UX01GZ Betriebsanleitung Seite 17

Multifunktions-antrieb
Vorschau ausblenden Andere Handbücher für UX01GZ:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 32
MAINTENANCE
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed before
attempting to perform inspection or maintenance on the
tool. Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
OPTIONAL ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
Refer to "Approved attachment" section for the applica-
ble models for this tool.
Brushcutter attachment
String trimmer attachment
Rotary scissors attachment
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Rotation is in reverse.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
17 ENGLISH
Cleaning the tool
Clean the tool by wiping off dust, dirt, or cut off grass with
a dry cloth or one dipped in soapy water and wrung out.
To avoid overheating of the tool, be sure to remove the
cut off grass or debris adhered to the vent of the tool.
Battery guard
WARNING:
Do not remove the battery guard.
Do not use the tool with the battery guard removed
or damaged. Direct impact to the battery cartridge
may cause battery malfunction and result in injury and/
or fire. If the battery guard is deformed or damaged,
contact your authorized service center for repairs.
► Fig.23: 1. Battery guard
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Change the direction of rotation with the reversing
switch.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Grass trimmer attachment
Hedge trimmer attachment
Ground trimmer attachment
Pole saw attachment
Cultivator attachment
Edger attachment
Coffee harvester attachment
Shaft extension attachment
Power brush attachment
Power sweep attachment
Blower attachment
Pump attachment
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.

Werbung

loading