Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.3 - Installation
lnstall and level the appliance on a floor able to take its weight and in a place suitable for its size and use.
lnsert the plug into an appropriate socket. This appliance is already equipped with a Schuko plug. If the plug is not
suitable for your socket, please call an authorized electrician for assistance; do not attempt to change the plug by yourself.
If the plug is damaged in any way — do not attempt to use it. It must be replaced with a new plug.
Do not install the appliance in direct sunlight and close to heat sources. Do not allow the appliance to be exposed to rain.
Choose a dry and well-ventilated area to install the appliance. There should be at least 10 cm of open space along the
sides, top, and back of the freezer.
Before switching it on, place the appliance in upright position and wait at least four hours without moving the appliance.
This will give the refrigerant circuit time to settle and operate efficiently.
The appliance is for use in places within the temperature ranges defined according to the climatic class given on the Data
Label located on the back of the product. The appliance may not operate consistently if placed for extended periods in an
area with a temperature below the cold end of the climate class temperature range for which the appliance is designed.
If the appliance is installed next to another refrigerator or freezer, observe the minimum
distance of 10cm to avoid condensation.
The manufacturer is not responsible for any failure caused by an incorrect installation.
Operating voltage for the appliance fridge is 220-240 V at 50Hz, 1 Phase.
1.4 - Conformity Information
The appliance is designed in compliance with the Directive 2011/65/EU, IEC60335-2-24, IEC60335-1. Directive
2004/108/EC, EN55014-1:2006/+A1:2009,
EN55014-2:1997/+A1:2001/+A2:2008, EN61000-3-2:2006/+A1:2009/+A2:2009 and EN61000-3-3:2008.
- 4 -
Werbung
