Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Operation
4.1 Safety
CAUTION
• The heated throw is fitted with the SAFETY SYSTEM. This electronic sensor technology provides
protection against overheating across the entire surface of the heated throw with an automatic
switch-off if there is a fault.
• Please note that, for safety reasons, the heated throw can no longer be operated after a fault has
occurred and must be sent to the specified service address.
• Do not connect the defective heated throw with another control of the same type. This would trigger
a permanent switch-off via the control safety system.
4.2 Initial use
• First, connect the control to the heated throw by inserting the plug-in coupling.
• Then plug the mains plug into the socket.
4.3 Switching on
To switch the heated throw on, set the sliding switch for ON/OFF and temperature
settings to setting 1, 2, 3, 4, 5 or 6.
When it is switched on, the indicator lamp (4) lights up.
4.4 Setting the temperature
Level 0:
OFF
Level 1:
minimum heat
Setting 2 - 5: individual heat setting
Level 6:
maximum heat
NOTE
The fastest way to warm up the heated throw is to initially set the highest temperature setting.
WARNING
If the heated throw is being used over several hours, we recommend that
you set the lowest temperature setting on the control to avoid the body
overheating and thereby any potential burns to the skin or heat stroke.
4.5 Automatic switch-off
This heated throw switches off automatically after 3 hours. Once the heated throw has switched off, it is no
longer heated and the indicator lamp flashes.
To switch on the heated throw again, first set the sliding switch for ON/OFF and temperature settings to the
OFF ( 0 ) position for 5 seconds. After about 5 seconds it is possible to switch it on again.
4.6 Switching off
To switch off the heated throw, slide the sliding switch for ON/OFF and temperature settings to the OFF (
0 ) position.
NOTE
If the heated throw is not being used for several days, slide the sliding switch for ON/OFF and tem-
perature settings to the OFF ( 0 ) position and remove the mains plug from the socket.
Then disconnect the control from the heated throw by unplugging the plug-in coupling.
13
Werbung
