Sundirect Smart2.0 Bedienungsanleitung Seite 4

3. Operation
3.1 Pair to the receiver
All "Plus" range heaters have a built-in
thermostat receiver-Receiver01 on the backside
of the panel. On the right, see the drawing of
the signal lights and button of Receiver01. The
following is a detailed description of the
buttons and signal lights:
1.Pair status signal light (green light)
2.Heating status signal light (red light)
3."P" button
4. Power switch
Step1: Plug your heater to an electricity outlet, switch the Power switch of
Receiver01 on, double press the "P" button and the "Pair signal light" will
start to flash and is ready for pairing.
Step2: Power-off the Smart2.0, long press the "SET" button. The "PAIR" signal
will show on the screen of the remote control. Wait until the "Pair signal
light" stops flashing and glows green to finish the pairing.
Note: Once Receiver01 and Smart2.0 are paired, the pair signal light will
always be on and the Receiver01 will be only commanded by the Smart2.0.
One Receiver01 can only pair to one Smart2.0, however, one Smart2.0 can be
paired to up to 10pcs Receiver01 if they are in the same room.
3.2 Time settings and temperature calibration
Power on Smart2.0. Press the "SET"
button for 3 seconds to enter the
settings.
The screen on the thermostat will
show as below and the minutes of
the timer setting will start to flash.
4