Remote Control - AVer MD120UI Bedienungsanleitung

Remote Control

The remote control requires two AAA batteries. Make sure batteries are installed properly before use.
1
HOME REC SNAP
2
3
4
5
MIC PRIVACY SPEAKER
6
X
7
Model: LY033
8
Name
9
1. Power
10
2. Home
11
3. Number
Pad
12
13
14
4. Preset
15
16
17
5. Zoom +/-
6. MIC
7. Camera
Select
8. Remote
Control
LED
9. Menu
10. Snap
11. Rec
12. Reset
13. Direction
Function
Short press to turn on/off Standby Mode.
Move the camera to the Home position.
 Press buttons 0~9 to move the camera to the
pre-configure preset positions.
 Use the buttons to set up preset positions 0~9.
Use the Preset, Number and Direction Buttons to
set up preset positions:
1. Use the Direction Buttons to navigate a
position. Optionally use the "Zoom +" or "Zoom
-" buttons to zoom in/out the image.
2. Press and hold Preset, then press the Number
Buttons (0~9) to save this preset position.
Press to zoom in or zoom out the images.
Press to mute the microphone. Press again to
unmute.
Select a camera to operate. Specify a number in
the OSD menu: System > Camera Selector.
When pressing the buttons on the remote control,
the LED will light red.
Press and hold for 3 seconds to open the OSD
menu. Edit this setting in the OSD menu: System >
Trigger OSD.
N/A
N/A
Use the Reset and Number Buttons to cancel a
pre-configured preset position. Press and hold
Reset, then press the Number Buttons (0~9).
Use the Direction Buttons to navigate the live view.
11