Charging The Battery - Kenwood CR-M30DAB Bedienungsanleitung

4.3 Information on LCD display

4.4 Charging the battery

To prevent the built-in battery from being damaged, it should be only half charged upon purchase. The
battery must be fully charged before using the radio for the first time.
For this, connect the "DC IN" connection with the supplied USB mains adapter and plug it in an easily
accessible socket.
While charging is in progress the LED lights up red above the connection. As soon as the battery is fully
charged the control light goes out. The usual charging time for an empty batter is approx. 4-6 hours. You
can use the radio while the charging is in progress, but doing so would prolong the charging time.
• Depending on environmental conditions, volume, etc. the playback time is approx. 5-7 hours
(with 50% volume).
• To maintain the full capacity of the battery as long as possible, you should fully charge the battery every
2 to 3 months, even if you do not use the radio.
• Charge the battery in ambient temperature of between 0 and +40°C.
• The battery maintains it's charge best at room temperature.
• The lower the ambient temperature, the shorter the playback time.
• The battery must be charged when the battery empty symbol appears on the Display.
Attention: The alarm function is not available in battery mode.
8
Alarm clock 1 display
Alarm clock 2 display
Sleeptimer remaining time
Volume
Selected Preset 1-20
Stereo reception display
RDS signal display
Reception strength
BLUETOOTH display
Battery level display