Parts Description - Makita DCB200 Bedienungsanleitung

PARTS DESCRIPTION

Fig.1
1 Battery holder (10.8 V -
12 V max)
Fig.2
1 Power cable
5 Extension cord
INSTALLATION
cartridge
CAUTION:
cartridge.
CAUTION:
Failure to hold the battery
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
Fig.3: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder (optional accessory)
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert the battery cartridge all the way until
it locks in place with a small click. If you can see the red
indicator on the upper side of the button, it is not locked
completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
CAUTION:
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
2 Battery holder (14.4 V 3
/18 V)
2 Battery pocket 3
- - -
Take the power cable out of the battery pocket and
connect the jack to the plug of the battery holder.
The battery holder (with battery cartridge) can be stored in
the battery pocket. Take the power cable out of the battery
pocket and connect the jack to the plug of the battery
holder. After that, put the battery holder (with battery car-
-
tridge) into the battery pocket and fasten the zip fastener.
fasten the fastener.
The belt hook on the battery holder can be detached by
removing the screws.
Using the extension cord
If you put the battery holder out of the battery pocket,
connect the extension cord between the jack of the
power cord and the plug of the battery holder.
NOTICE:
-
holder
If you hang the battery holder on your waist belt, attach
the belt hook of the battery holder to your waist belt, and
then connect the jack to the plug of the battery holder.
NOTICE:
strap hole and secure it.
The battery holder has an anti-drop function. When
removing the battery holder from the belt, pull up the
battery holder while pressing the unlock button.
10 ENGLISH
Belt hook 4
Power button 4
- -
Fig.4: 1. Power cable 2. Jack 3. Plug
Fig.5
CAUTION:
Fig.6: 1. Screw 2. Belt hook
Fig.7: 1. Extension cord 2. Jack 3. Plug
When using the extension cord, be
Fig.8: 1. Belt hook 2. Battery holder 3. Waist belt
4. Plug 5. Jack
Fig.9: 1. Unlock button
Strap hole
Heating element (inside)
-