Parts Description; Installation - Makita CJ105D Betriebsanleitung

PARTS DESCRIPTION

Battery holder (optional accessory)
► Fig.1
1 Battery holder for CXT
battery cartridge
5 Adapter cable
Model CJ105D / DCJ205
► Fig.2
1 Power button
Model CJ106D / DCJ206
► Fig.3
1 Power button
5 Hood
Model CV102D / DCV202
► Fig.4
1 Power button

INSTALLATION

Installing or removing the battery
cartridge
CAUTION:
Always switch off the device
before installing or removing the battery
cartridge.
CAUTION:
Hold the battery holder and the
battery cartridge firmly when installing or remov-
ing the battery cartridge. Failure to hold the battery
holder and the battery cartridge firmly may cause
them to slip out of your hands and result in damage
to the battery holder and battery cartridge and/or a
personal injury.
► Fig.5: 1. Red indicator 2. Button 3. Battery cartridge
4. Battery holder (optional accessory)
To install the battery cartridge, align the tongue on the bat-
tery cartridge with the groove in the housing and slip it into
place. Insert the battery cartridge all the way until it locks in
place with a small click. If you can see the red indicator on
the upper side of the button, it is not locked completely.
To remove the battery cartridge, slide it from the battery
holder while pressing the button on the front of the
cartridge.
CAUTION:
Always install the battery car-
tridge fully until the red indicator cannot be seen.
Otherwise the battery cartridge may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
CAUTION:
Do not forcibly install the battery
cartridge. If the battery cartridge does not slide in
easily, it is not being inserted correctly.
2 Battery holder for LXT
battery cartridge
- -
2 Battery pocket
2 Battery pocket
6 Name tag holder
2 Battery pocket
11 ENGLISH
3 CXT battery cartridge
(10.8 V - 12 V max)
- -
3 Jack
3 Jack
- -
3 Jack
Battery pocket
The battery holder (with battery cartridge) can be
stored in the battery pocket. Connect the power cable
jack pulled out of the battery pocket to the plug of the
adapter cable. Then put the battery holder into the
battery pocket and fasten the fastener.
► Fig.6: 1. Power cable 2. Jack 3. Adapter cable
4. Battery pocket
The belt hook on the battery holder can be detached by
removing the screws.
► Fig.7: 1. Screw 2. Belt hook
Attaching the battery holder
You can hang the battery holder on your waist belt.
To prevent the battery holder from dropping acciden-
tally, attach a strap using the strap hole and secure it.
1.
Pull the power cable out of the upper hole in the
battery pocket and feed the jack through the lower hole
in the battery pocket and pull it through to the inside of
the jacket or vest.
► Fig.8: 1. Power cable 2. Upper hole 3. Battery
pocket 4. Jack 5. Lower hole
2.
Attach the belt hook of the battery holder to your
waist belt. Connect the jack of the adapter cable to the
battery holder and connect the plug of the adapter cable
to the jack of the power cable.
► Fig.9: 1. Belt hook 2. Battery holder 3. Waist belt
4. Adapter cable 5. Power cable
The battery holder has an anti-drop function. When
removing the battery holder from the belt, pull up the
battery holder while pressing the unlock button.
► Fig.10: 1. Unlock button
4 LXT battery cartridge
(14.4 V / 18 V max)
- -
4 Code lock
4 Code lock
- -