Inhaltsverzeichnis
Werbung
A copy of the original declaration of conformity may be
obtained from Axis Communications AB. See Contact
information on page 10.
Electromagnetic compatibility (EMC)
This equipment has been designed and tested to fulfill
applicable standards for:
• Radio frequency emission when installed according to
the instructions and used in its intended environment.
• Immunity to electrical and electromagnetic phenomena
when installed according to the instructions and used
in its intended environment.
USA
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested using an unshielded
network cable (UTP) and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the
FCC rules. This equipment has also been tested using a
shielded network cable (STP) and found to comply with
the limits for a Class A digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
5
Werbung
Inhaltsverzeichnis
