Intex FastFill I637USB Benutzerhandbuch Seite 3

INFLATION
1. Open line cord compartment cover and pull out the USB cable. See Fig (1).
2. Connect the USB cable to one of the following external power adapters (not included):
• USB Wall Charger rated 5V
• Portable USB Charger rated 5V
• 12V Car Charger rated 5V
• USB Port rated 5V
USB Wall Charger
FIG (2)
3. Turn the control dial to the inflation mark (
FIG (6)
4. When the air bed is fully inflated, turn the control dial back to the off mark (
closing the inflation valve. See Fig (7).
5. Lie down on the air bed to test the firmness.
6. If the air bed feels too firm, release some air by simply turning the control dial to the
deflation mark (
the off mark (
SAVE THESE INSTRUCTIONS
/ 2A or more. See Fig (2).
/ 2A or more. See Fig (3).
/ 2A or more. See Fig (4).
/ 2A or more. See Fig (5).
Portable USB Charger
FIG (3)
Inflation
mark
) until desired firmness is achieved, then turn the control dial back to
) position. If the bed feels too soft, repeat steps #3 to #6 as necessary.
(37IO) I637USB ELECTRIC PUMP ENGLISH 4.875" X 7.25" 04/19/2023
FIG (1)
12V Car Charger
FIG (4)
). See Fig (6).
Page 3
37
IO
5V/2A USB Port
FIG (5)
FIG (7)
) position