Guarantee & Service - Philips FC6146 Bedienungsanleitung

English
1
1 Let the vacuum cleaner run until it stops.
Try to switch on the appliance again to check if the batteries are really
empty. If the motor starts, repeat the procedure.
 Loosen and remove the screws. Open the vacuum cleaner (Fig. 25).
 Put the motor unit with the batteries still attached in a large bowl
with 3 litres of water and 3 teaspoons of salt.
- Make sure the whole motor unit is immersed. Add more water and
salt according to the above proportion (1 teaspoon salt to 1 litre of
water) if needed.
- Leave the motor unit and the batteries in the bowl for 24 hours.
 Cut the connecting wires one by one and remove the batteries
(Fig. 26).
guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Customer Care Centre in your country,
go to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Customer Care Centre in your
country.
Problem
The appliance
does not work.
Solution
The batteries may be low. Recharge the batteries.