English - Braun Création diffusor CPC 1600 DFB 6 Gebrauchsanweisung

English

Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
• Plug your hairdryer into an alternating current
(Ù) outlet only and be sure that your household
voltage corresponds to the voltage marked on
the hairdryer.
• Do not allow the appliance to become
wet.
• When using the hairdryer in a bathroom, always
unplug it after use. Even a switched-off hair-
dryer presents a hazard if not unplugged.
• For additional protection, it is advisable to
install a residual current device (RCD) with a
rated residual operating current not exceeding
30 mA in the electrical circuit of your bath-
room. Ask your installer for advice.
• Care should be taken not to block the inlet and
outlet grill when the hairdryer is switched on. If
either grill becomes blocked, the hairdryer will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
• Do not wrap the mains cord around the ap-
pliance. Regularly check the mains cord for
wear or damage, particularly where it enters the
product and the plug. If you have any doubt
about its condition take the appliance to your
nearest Braun Service Centre for checking/
repair. The mains cord of the appliance may
only be replaced by an authorised Braun
Service Centre. Unqualified repair work can
lead to extreme hazards for the user.
Description
1
Switch
2
Cold shot button
3
Long-life Filter
4
Concentrator nozzle
5
Diffusor attachment
Switch settings 1
0 = off
1 = gentle drying
2 = fast drying
2
Cold shot
To fix a style with cold air, press the cold shot
button.
3
Long-life Filter
Regularly wipe the filter clean. For a thorough
cleaning, remove the filter and clean it under
running water.
Concentrator nozzle
For precise styling use the concentrator nozzle.
Diffusor attachment
Attaching the diffusor
• Align the notches on the rim of the diffusor
attachment with the slots in the hair dryer.
• Push the attachment onto the hairdryer, then
turn clockwise until the bayonet lock clicks
into place.
• To remove the diffusor, turn in the opposite
direction and pull.
Volume styling
• Short to mid-length hair:
To add volume and root lift, gently guide the
diffusor fingers with a small circular motion
over your scalp. Continue section by section.
• Long hair:
First dry hair ends by placing them onto the
finger plate. Then, with the diffusor, carefully lift
the hair to your head and hold. Finish off the
roots with a gentle circular movement of the
diffusor fingers on the scalp to add some lift.
Subject to change without notice.
This product conforms to the EMC-Directive
89/336/EEC and to the Low Voltage Regulation
73/23 EEC.
4
5
5