System Settings - auna V-20 DAB Bedienungsanleitung

• NFC: When enabled on the transmitting audio device; all that is required is for you to touch the NFC
logo on the front of the micro system with the NFC hotspot on your compatible audio device. Enable
NFC on your audio device (such as a mobile phone). Touch the NFC hot spot on your audio device to
the NFC logo on the front of the micro system. You may need to move the device around slightly to hit
the exact contact point. When the connection is made, a melody is played and the 'BT-LINK' text on the
display will stop flashing and the device will be automatically connected.
• To remove a paired device using the micro system, press and hold the UNPAIR/ENTER button on the
micro system or press the UNPAIR button on the remote The 'BT LINK' text will begin flashing again.
• Aux-In: Use a 3.5mm audio cable to connect external media/audio players to the AUDIO IN socket
on the rear. Press SOURCE repeatedly to switch to AUX mode. Operate the playback on your external
device. If using the headphone out, set it to about 70% volume, to avoid hum. Adjust the output volume
on the V-20, then.
When the unit is standby mode the backlight will dim after 10 seconds. Press the LIGHT button on the remo-
te control to illuminate the backlight for 10 seconds.
The system settings (TIME/DATE, AUTO UPDATE, FACTORY RESET) are accessible through the MENU but-
ton: Press MENU (RC: hold), then scroll through the list, using the arrow buttons. Press ENTER to enter sub
menues or confirm any change. Use the arrow buttons to adjust values.
To reset the device to factory presets, press MENU and use the arrow buttons to select the SYSTEM sub
menu. Scroll through to SYSTEM RESET with the arrow buttons, then press ENTER. Please note: All station
presets and changes will be deleted.
18
AUX
Display Illumination

System Settings

Factory Reset