Intended Use; Technical Description; Installing The Device; Mounting The Device - Dometic GP-MPPT-100/30 Montage- Und Bedienungsanleitung

Intended use

All other actions are intended also for non-professional users.
4 Intended use
The solar charge controller protects the battery from being overcharged by the solar energy.
The device is intended for use at 12 V and 24 V system voltage, and suitable for use with lead acid (flooded, gel, or
AGM type) and LiFePO4 batteries.
The device is intended to be installed on transport trucks, delivery vehicles, work trucks and heavy duty equipment.
The controller is built to withstand being used in harsh industrial conditions.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible fail-
ure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product specifications.

5 Technical description

The device is an Industrial Maximum Power Point Tracking (MPPT) controller featuring a
robust, fully-sealed housing that resists vibration as well as dust-, insect- and water ingress.
The controller is equipped with 3 LEDs to display the operating status. In normal operation, the controller shows
the connection and charging status, and the battery state of charge.
The device has the following features:
• Waterproof protection with MC4 solar connections and Delphi battery connections
• Up to 98% power conversion efficiency
• 3-stage I/U curve sweep algorithm increases battery lifespan
• Anodized aluminum extrusion with built-in heat dissipation
• Fully encapsulated design prevents damage from water, corrosion, insects and/or dust
• Works with 12 or 24 V battery systems (automatic battery voltage detection)
• Compatible with 60-cell modules
• Converts excess array voltage into additional charging current
• Allows up to 50% oversized array power for adding additional capacity in low-insolation months

6 Installing the device

6.1 Mounting the device

A
NOTICE! Damage hazard
The controller warms up during operation. Make sure it is installed on a non-flammable
surface.
6
GP-MPPT-100/30
EN