Preparations For Use - Candy CMCL 5142WN Bedienungsanleitung

No
1
2
3
4
5
6
7
The most energy-saving configuration requires
drawers, food box and shelves to be positioned in
the product, please refer to the above pictures.
Due to technological innovation, the descriptions
of the product in this manual may not be
completely consistent with your refrigerator.
Details are in accordance with the material item.

Preparations for use

Installationlocation
1. Ventilation condition
The position you select for the refrigerator
installation should be well-ventilated and has less
hot air. Do not locate the refrigerator near a heat
source such as cooker, boiler, and avoid it from
direct sunlight, thus guaranteeing the refrigeration
effect while saving energy consumption. Do not
locate the refrigerator in the damp place, so as to
prevent the refrigerator from rusting and leaking
electricity. The result of the total space of the room
in which the refrigerator is installed being divided
by the refrigerant charge amount of the
refrigerator shall not be less than 8 g/M
Note: The amount of refrigerant charged for the
Description
Thermostat
Fridge glass shelf
Crisper cover
Crisper
Freezer drawer
Leveling foot
Bottle rack
3
.
refrigerator can be found on the nameplate.
2. Heat dissipation space
When working, the refrigerator gives off heat to
surroundings. Therefore, at least 300 mm of free
space should be spared at the top side, more than
100 mm on both sides, and above 50 mm at the
back side of the refrigerator.
3. Level ground
Place the refrigerator on the solid and flat ground
(floor) to keep it stable, or else, it will give rise to
vibration and noise. When the refrigerator is
placed on such flooring materials as carpet, straw
mat, polyvinyl chloride, the solid backing plates
should be applied underneath the refrigerator, so
as to prevent color change due to heat
dissipation.
Unobstructed ventilation shall be
maintained around the appliance or in an
embedded structure.
Preparations for use
1. Standing time
After the refrigerator is properly installed and well
cleaned, do not switch it on immediately. Make
sure to energize the refrigerator after more than 1
hour of standing, so as to ensure its normal
operation.
2. Cleaning
Confirm the accessory parts inside the refrigerator
and wipe the inside with a soft cloth.
3. Power-on
Insert the plug into the solid socket to start the
compressor. After 1 hour, open the freezer door, if
the temperature inside the freezer compartment
drops obviously, it indicates the refrigeration
system is working normally.
4. Storage of food
After the refrigerator runs for a period of time, the
internal temperature of the refrigerator will be
automatically controlled according to the user's
temperature setting. After the refrigerator is fully
cooled, put in foods, which usually need 2~3 hours
to be fully cooled. In summer, when the
temperature is high, it takes more than 4 hours for
the foods to be fully cooled (Try to open the
refrigerator door as less as possible before the
internal temperature cools down).
If the refrigerator is installed in the moisture
place, make sure to check whether the ground wire
and leakage circuit breaker are normal. If vibration
noises are produced due to the refrigerator
contacting the wall or if the wall gets blackened by
11